- Knowledge Base
- Equipment Install Guides and Settings
- Kubota M5 Cab and ROPS
Kubota M5 Cab - Brake Actuator Installation
This article shows how to install a Service Brake Actuator on a Kubota M5 Cab Tractor
Video walking through the Install of the actuator
Video walking through the Install of the actuator linkage
Step 1
Remove the two bolts on the right side of the seat and bolt on the actuator mount bracket using M8 x 35mm Bolts
Step 2
Mount the Ewellix Actuator. Place the weatherstripping around the surface where the actuator will be clamped. Failure to place weather stripping may cause damage to actuator.
Step 3
Clamp Brake Pedal with bracket and M6 x 35mm bolts
Step 4
Pin linkage to pedal and actuator.
Step 5
Calibrate the Brake Actuator and Verify proper function. The rod end on actuator can be adjusted for fine tuning the gap between the linkages.