vMC 1.26.33

Improvements

• Fixed an issue where pull-type implements could default to the wrong attachment point ("Rear-hitch" instead of "Drawbar") for users without the v2 measurements feature flag enabled.
• Fixed an issue where the Engage PTO button remained enabled when the 3-point hitch was in a raised or raising state until the page was manually refreshed.
• Improved equipment measurements to allow swath width to exceed implement width, so coverage plans for spreaders, sprayers, and other implements that disperse material wider than their physical frame generate correctly spaced passes.
• Improved the device uninstall experience to surface errors when an uninstall fails and handle stuck-device states in the UI instead of silently swallowing failures.
• Fixed an issue where drawing geometry on a field with overlapping boundaries would interact with the wrong field boundary, preventing users from creating or editing geometry on the intended field.
• Fixed an issue where mission generation would fail with an error when no implement was attached to the tractor.
• Fixed an issue where completed passes could block headland assignment, preventing users from generating missions for remaining headland passes without recreating the entire coverage plan.
• Fixed an issue where creating a new template through the workflow and then continuing to a mission would not use the newly created template.
• Fixed an issue where the dynamic pass speed override control remained enabled even when the implement was reporting a desired pass speed above zero.